Fire Bucket Stands & Fire Points — Buyer FAQ
What is the standard fire bucket stand size?
There is no size set by a standard. In practice a 4-bucket stand is the common configuration, built from angle iron to about waist height with a back plate for signage, holding 9 litre buckets of roughly 260 mm diameter. Two and six bucket versions and canopied versions are all made to order.
What is the purpose of a fire bucket stand, and what are fire buckets used for?
A fire bucket stand keeps sand or water buckets upright, full, off the ground and visible at a fire point, so they cannot be borrowed for other work or knocked over. Fire buckets are used to smother a small fire at its start — sand for a liquid or fuel spill fire, water for ordinary combustibles — before it grows past what a first responder can handle.
What is the height and width of a fire bucket stand?
There is no size fixed by a standard. A 4-bucket stand is typically built to about waist height so the buckets can be lifted without stooping, with the frame wide enough to space four 9 litre buckets of roughly 260 mm diameter along the rail, plus a back plate for signage. Give us the bucket count and the diameter you use and we set the frame around them.
Where are fire bucket stands required?
Rules vary by country and by industry. They are most often specified at fuel dispensing points, LPG stores, fuel depots and industrial yards, usually alongside dry-powder extinguishers. Your local authority or insurer sets the requirement — we build to what your specification asks for rather than quoting a rule that may not apply to your site.
What is a fire point station or fire point trolley?
A fire point is a marked location holding the firefighting equipment for an area — typically extinguishers, a sand bucket or box, and a signage panel. A static fire point station bolts down; a fire point trolley puts the same equipment on wheels so it can follow hot work around a site.
Do you supply the buckets and the sand?
Buckets yes — 9 litre, conical or flat-base, painted red and marked. Sand no: it is heavy, cheap locally, and not worth the freight. Fill on site.
Can you make stands in stainless or galvanised steel?
Yes. Powder-coated steel is standard; hot-dip galvanising suits wet and coastal yards; SUS 304 or 316 where the atmosphere is chemically aggressive or the client wants a finish that will not chip.
What quantities do you supply?
We are set up for batches — dealer stock orders, project quantities and OEM programmes. Simple welded steelwork sells locally at low per-piece prices, so a single stand from us rarely makes sense; a container of stands with your branding usually does.
Can these ship with a cabinet order?
Yes, and that is the usual arrangement. Stands and sand boxes flat-pack, so they fill the gaps around cabinets in a container and cost very little extra freight.
Can you build a fire point to our own drawing?
Yes — send a sketch, a photo or a DWG. Frames, heights, bucket counts, cradle types and signage wording are all made to order, with no tooling charge for a new configuration.
